Autopilot Hub wiring

The autopilot wiring runs to a central hub, provided by SteinAir. This simplifies the wiring runs and the CAN bus. However, I needed to determine the length of wire to run from the hub to each component.

Estimated Lengths
GSA 28 HUB to:
GDL 39R (ADB weather/traffic)

• 20 AWG black/red (power/ground) ~20 ft.
• 22 AWG shielded 2 conductor (signal) ~20 ft.

GTX 23ES (transponder): 

• 20 AWG black/red (power/ground) ~15 ft.
• 22 AWG shielded 2 conductor (signal) ~15 ft.

GSA 28 (A/P roll servo)

• 20 AWG black/red (power/ground) ~20 ft.
• 22 AWG shielded 2 conductor *2 (RS232 and CAN signal) ~40 ft. @ 20 ft. ea.

GSA 28 (A/P pitch servo)

• 20 AWG black/red (power/ground) ~1.5 ft.
• 22 AWG shielded 2 conductor *2 (RS232 and CAN signal) ~3 ft. @ 1.5 ft. ea.